![]() ![]() If there is no adjacent wall or floor member that is perpendicular to the screen, tape a second line on the floor perpendicular to both the alignment screen and the first line, and outboard of either side of where the vehicle will be positioned. ![]() The level floor will be used as the horizontal zero reference.Ģ.An adjacent wall or floor member that is perpendicular to the alignment screen can be used as the vertical zero reference. Refer to the Lamp Alignment Screen Distance table for the appropriate measurement. The procedure that follows will prepare a suitable front lamp alignment screen.ġ.Tape a line on a level floor at the appropriate distance away from and parallel to the flat wall that will be used as the lamp alignment screen. Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated gallon of missing fuel.ħ.Verify the correct vehicle suspension height. 5.Verify that there is no load in the vehicle (cargo or passengers), except for the driver.Ħ.The fuel tank should be FULL. There is a headlight aiming procedure.Ġ8 - Electrical / 8L - Lamps and Lighting / Lamps/Lighting - Exterior / Standard Procedureġ.Check for and correct any burnt out bulbs.Ģ.Repair or replace any ineffective, worn or damaged body or suspension components that could hinder proper lamp alignment.ģ.Verify the proper tire inflation pressures.Ĥ.Remove any accumulations of mud, snow or ice from the vehicle underbody and clean the front lamp lenses. Many aftermarket headlights assemblies do not have the little motor for the high beam shutter. HID headlights need a different BCM that has fuses for the ballasts. LED headlights will give a headlight out error. The Dart BCM (Body Control Module) is fussy about headlights. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |